Skip to main content

BEND TESTS


BEND TESTS

Object: 

To determine the soundness of weld metal, heat affected zone and weld zone.These tests may also be used to give some measure of the ductility of the weld zone. It is not usual to use transverse and longitudinal bend tests for the same application.

Method: 

All specimens to be removed and prepared without causing significant distortion or heating. The cap and root are ground flush. The specimen is bent by the movement of a former of prescribed diameter, the relevant side of the specimen to be placed in tension. Angle of bend and diameter of former should be as specified in the appropriate standard.

Reporting Results:
  • Thickness of specimen
  • Direction of bend (root or face)
  • Angle of bend
  • Diameter of former
  • Appearance of joint after bending e.g. type and location of flaws



Labels:

Popular posts from this blog

LIQUID (DYE) PENETRATION TEST (D.P.T.)

LIQUID (DYE) PENETRATION TEST INTRODUCTION A liquid penetrant test is non-destructive type of testing to detect flaws that are open to the surface. e.g. cracks, seams, laps, lack of bond, porosity, cold shuts etc. can be effectively used not only in the inspection of ferrous metals but is especially useful for non-ferrous metal products and on non-porous, non-metallic materials such as ceramics, plastics and glass. PRINCIPLE OF OPERATION The principle of liquid penetrant test is that the liquids used enter small openings such as cracks or porosities by capillary action. They are influenced by factors such as the condition of the surface of material and the interior of the discontinuity. For liquid to penetrate effectively, the surface of the material must be thoroughly cleaned of all material that would obstruct the entrance of the liquid into the defect. After cleaning, the liquid penetrant is applied evenly over the surface and allowed to remain long enough to permit penetration i...
Read more

NDT ( NON DESTRUCTIVE TESTING )

NDT (NON DESTRUCTIVE   TESTING) :-  Non Destructive Testing in great variety are in world   wide used to detect variations in structure, minute changes in surface finish, the presence of cracks or other physical discontinuities, measure   the thickness   of materials   and   coatings   and   to   determine  other characteristics of industrial products. REASON'S FOR THE USE OF NDT: "NDT" is used by the manufacturers for the following reasons:  1. To ensure product reliability. 2. To make profit for the user. a)    To ensure customer satisfaction b)   To aid in better product reliability. c)    To control the manufacturing processes. d)   To lower the manufacturing costs. e)    To maintain uniform quality level. SOME OF THE MOST COMMON NDT METHODS ARE : 1.VISUAL ...
Read more