Skip to main content

Contact us

https://opportunitytowin.blogspot.in/ Allows User Articles And Instant We providing instant replies for user feedbacks and comments.


Usually We Response all Our Users Within No Longer Than 24 Hours. For Guest Posts Contact Us Via Email Only. Your Requests Must Have Cleared Contents And Valid Email Of Your Original profile.

Contact Our Team For Feedbacks And Suggestions :


We Share We Care…

Popular posts from this blog

The Brinell Hardness Test

The Brinell Hardness Test The Brinell hardness test method consists of indenting the test material with a 10 mm diameter hardened steel or carbide ball subjected to a load of 3000 kg. For softer materials the load can be reduced to 1500 kg or 500 kg to avoid excessive indentation. The full load is normally applied for 10 to 15 seconds in the case of iron and steel and for at least 30 seconds in the case of other metals. The diameter of the indentation left in the test material is measured with a low powered microscope. The Brinell harness number is calculated by dividing the load applied by the surface area of the indentation. The diameter of the impression is the average of two readings at right angles and the use of a Brinell hardness number table can simplify the determination of the Brinell hardness. A well structured Brinell hardness number reveals the test conditions, and looks like this, "75 HB 10/500/30" which means that a Brinell Hardness of 75 was obtained us...
Read more

Part - 6 Most commonly asked Mechanical Interview Questions with answer

Most commonly asked Mechanical Interview Questions  1.           Why Entropy decreases with increase in temperature? Ans.      ds=dQ/T Entropy is inversely proportional to the temperature so, as temp. Increases, entropy decreases. 2.            Why different types of sound are produced in different bikes, though they run on SI Engines? Ans.        Engine specifications are different in different manufactures like as Bore Diameter (CC), Ignition timing. Also the exhaust passage takes more responsible for sound. 3.            How much Watt means 1Hp? Ans.       746.2 Watt 4.            Explain Bicycle Rear Wheel Sprocket working? Ans.       Rear wheel sprocket works u...
Read more

Vickers Hardness Test

Vickers Hardness Test:- The Vickers hardness test method consists of indenting the test material with a diamond indenter, in the form of a right pyramid with a square base and an angle of 136 degrees between opposite faces subjected to a load of I to I 00 kgf. The full load is normally applied for I 0 to 15 seconds. The two diagonals of the indentation left in the surface of the material after removal of the load are measured using a microscope and their average calculated. The area of the sloping surface of the indentation is calculated. The Vickers hardness is the quotient obtained by dividing the kgf load by the square mm area of indentation. F= Load in kgf d = Arithmetic mean of the two diagonals, di and d2 in mm HV = Vickers hardness When the mean diagonal of the indentation has been determined the Vickers hardness may be calculated from the formula, but is more convenient to use conversion tables. The Vickers hardness should be reported like 800 HV/10, which means a Vickers...
Read more